2010-2019 Ford Taurus (6th Generation) • Re: Coolant leak… ( completely empty )
What car do you have? Any visible leaks? On my 2003 Taurus the overflow tank had a crack in it on the bottom years ago. Only leaked once it got up to temperature and wasn't obvious where the leak was...
View ArticleFord Police Interceptor 2013-newer • Re: New bcm and bcm location
Incorrect. I finally got to spend hours on this car. The BCM is behind the glove box on passenger side. Will post a pic. I look up the part number and it calls it BCM. It had 5 connectors plugged into...
View Article2010-2019 Ford Taurus (6th Generation) • Re: BCM 2017
OK long time coming. The BCM for this car is behind the glove box. It is not on drivers side with all the fuses in it. I found it and looked up the numbers and when I figure out how to post a picture....
View Article1996-1999 Ford Taurus & Mercury Sable (3rd Generation) • Re: Upper...
fOUND ON AMAZON m6 X 1 X 80MM 8.8 HARDNESS
View Article1996-1999 Ford Taurus & Mercury Sable (3rd Generation) • Upper manifold...
i need the bolts for my 1999 dohc intake upper manifold a part number and a dealer source would be nice there are 6 bolts 3 long ones and 3 shorter ones i have broken one of the longer ones i have...
View Article2000-2007 Ford Taurus & Mercury Sable (4th Generation) • Re: Long Cold...
After 2-3 hour delay had me thinking of fuel prssr until you mentioned 45-60 psiThe 06 SEL Im dealing with runs perfect, except after sitting (winter or summer), and 'sluggish'(?) often on cold...
View Article2000-2007 Ford Taurus & Mercury Sable (4th Generation) • Long Cold Crank...
Problem: Long crank time when car sits overnight or after 2-3 hours.Crank time is 3-6 seconds. After restart, it starts within 2 seconds.Runs great other than that. No CEL codes. Live Stream shows no...
View Article2000-2007 Ford Taurus & Mercury Sable (4th Generation) • Re: 2000 Ford...
Ive had similar issues on same vintage motors. A new hose, even if not OE, but stiff solved the problem on a Ranger and an older BMW
View ArticleFord Police Interceptor 2013-newer • Re: P0430 - Cat or sensor? Not so fast!
Hi!It would be the lower half of the intake manifold, the part that actually bolts to the engine.I hate to say it, but if your headgasket is beginning to leak, that could allow coolant to be burnt as...
View Article2010-2019 Ford Taurus (6th Generation) • Coolant leak… ( completely empty )
Today, I got a coolant light on my dash. I immediately pulled over to check the coolant levels, and it turned out my coolant was completely empty, so I decided to add orange 50/50 coolant. However,...
View Article2000-2007 Ford Taurus & Mercury Sable (4th Generation) • Re: Cutting out...
why not cut springs to OE length ?Is there an issue with the strut inserts ?
View Article2010-2019 Ford Taurus (6th Generation) • Re: How do I prevent water pump damage
Proactive coolant replacement can help a little, only buy new Ford Motorcraft coolant, not generic Prestone.
View Article2010-2019 Ford Taurus (6th Generation) • How do I prevent water pump damage
Since my taurus is FWD I don't have to worry about PTU, but I don't know how to prevent water pump damage.Any tips?
View Article2010-2019 Ford Taurus (6th Generation) • Re: 3rd Brake Light Connector 2018...
FWIW, my glass guy used the conductive glue (superglue with copper) like with rear window defroster and glued to tabs back in. Light installed and moving forward.
View Article2000-2007 Ford Taurus & Mercury Sable (4th Generation) • Re: Taller tire...
Personally I prefer to not go more than one size difference (e.g. 215 vs 225) and not change the aspect ratio unless you do the proper calculations and go 1" smaller diameter when possible (think...
View Article2008-2009 Ford Taurus & Mercury Sable (5th Generation) • Re: 2008 Taurus...
The upper mounting bolts are usually located along the top edge of the bumper cover, under the hood near the radiator support. Hopefully the mounting points weren't damaged in the collision.
View Article2000-2007 Ford Taurus & Mercury Sable (4th Generation) • idler Pulley...
Is there a removal tool for this task?
View ArticleFord Police Interceptor 2013-newer • Improving front seat support 2017 Taurus
Hi. Couldn't find anything about this by search. My 2017 Taurus has what to me are pretty bad seats. I'm 6'2" and didn't notice on the test driving how uncomfortable they were until the long drive...
View ArticleFord Police Interceptor 2013-newer • Push bar mounting
Anyone have any images and dimensions for the setina push bar mounts? Have only been able to find mediocre pictures with nothing in them to reference size. If anyone has pictures or the time to remove...
View ArticleFord Police Interceptor 2013-newer • Improving front seat support.
Hi. Couldn't find anything about this by search. My 2017 Taurus has what to me are pretty bad seats. I'm 6'2" and didn't notice on the test driving how uncomfortable they were until the long drive...
View Article
![[TVRIP] Vertex Force [バーテックスフォース] 第01話](http://animerss.com/img/TVRIP-Vertex-Force.jpg)
